We are pleased to welcome a new postdoc to the Ameloot group!

Point-of-care (POC) devices require more advanced detection techniques than those currently available to achieve enhanced quantification and sensitivity. Incorporating a micro power supply could be a

Precise control over the crystalline phase and crystallographic orientation within thin films of metal-organic frameworks (MOFs) is highly desirable. Here, we report a comparison of the liquid- and

In this work, we investigate the vapor-assisted synthesis of the metal-organic framework MOF-74 starting from three metal oxides (ZnO, CoO, and MgO). Depending on the nature of the added vapor (H2O,

Congratulations Dr. Vanduffel! After successfully completing the public defense of her thesis, Hanne was awarded her Ph.D.!

After writing her Master's thesis at the Ameloot group working on integrating MOFs in a gas sensor, Leen now joins the group as a Ph.D. student. During the following years, she will implement a novel

Grayscale masks have been applied in high-end stereolithography (SLA) 3D printers to spatially define the degree of photopolymerization and fabricate objects with graded properties.

Their chemical diversity, uniform pore sizes, and large internal surface areas make metal−organic frameworks (MOFs) highly suitable for volatile organic compound (VOC) adsorption. In this work, we compare two geometries of capacitive VOC sensors that use the MOF material ZIF-8 as an affinity layer.

Graded porous materials (GPMs) with fine pore sizes (<50 μm) and gradient porosity are used in diverse fields such as biomedical implants, sensors, and soft robotics. Stereolithography (SLA) 3D

Congratulations to Víctor Rubio-Giménez for receiving the best senior oral presentation award at the EuroMOF / Baltic ALD conference! Check out his article on the chemical vapor deposition of Cu-BHT