After writing her Master's thesis at the Ameloot group working on integrating MOFs in a gas sensor, Leen now joins the group as a Ph.D. student. During the following years, she will implement a novel

Grayscale masks have been applied in high-end stereolithography (SLA) 3D printers to spatially define the degree of photopolymerization and fabricate objects with graded properties.

Their chemical diversity, uniform pore sizes, and large internal surface areas make metal−organic frameworks (MOFs) highly suitable for volatile organic compound (VOC) adsorption. In this work, we compare two geometries of capacitive VOC sensors that use the MOF material ZIF-8 as an affinity layer.

Graded porous materials (GPMs) with fine pore sizes (<50 μm) and gradient porosity are used in diverse fields such as biomedical implants, sensors, and soft robotics. Stereolithography (SLA) 3D

Congratulations to Víctor Rubio-Giménez for receiving the best senior oral presentation award at the EuroMOF / Baltic ALD conference! Check out his article on the chemical vapor deposition of Cu-BHT

In this paper, powder-based three-dimensional (3D) printing was combined with sacrificial templating to realize highly porous yttria-stabilized ZrO2 (YSZ) ceramic foam objects with well-defined

Welcome Masaya!

A warm welcome to Paul!

Vapor-phase film deposition of metal–organic frameworks (MOFs) would facilitate the integration of these materials into electronic devices. In this study, we report the vapor-phase layer-by-layer deposition of zeolitic imidazolate framework 8 (ZIF-8) by consecutive, self-saturating reactions of diethyl zinc, water, and 2-methylimidazole on a substrate.

After obtaining his Master's degree in physics engineering, João worked as a junior research fellow at the International Iberian Nanotechnology Laboratory. Now, he joins the Ameloot group to pursue a PhD.